GN7C Installation Manual
GN7C Installation Manual
1. SECURITY INFORMATION
The vehicle alarm system shall be installed inside the passenger compartment of the vehicle, in a place difficult to access in accordance with the manufacturer's supplied wiring instructions.
The manufacturer of the alarm system recommends the following:
- Qualified Installation: Choose a qualified vehicle alarm system installer to fit the device.
- Environment: The system unit (see Pic 1) shall be installed in a place free from moisture and other elements that could pose to corrode the device.
- Interference: Install as far as possible from any heat-emitting elements in the passenger compartment and sources of electromagnetic interference (e.g., vehicle computer, fans, relay blocks).
- Condensate Prevention: Avoid mounting the System unit directly onto metal parts of the vehicle to prevent the accumulation of condensate.
- Orientation: Install the System Unit so that the wire connectors exit from the bottom side of the unit.
- Safety: Avoid placing wires next to moving or hot parts of the vehicle.
Circuit Load Limits
Do not overload the following circuits of the alarm system:
| Circuit | Maximum Current |
|---|---|
| Cut-off circuit (Δ symbol) | No more than 25 A |
| Optional control No. 1 circuit (4) | No more than 0.13 A |
| Optional control No. 2 circuit (6) | No more than 0.13 A |
| Siren (square symbol) | No more than 2 A |
| Direction indicator on the right circuit (5) | No more than 7 A |
| Direction indicator on the left circuit (2) | No more than 7 A |
2. SEQUENCE OF SYSTEM INSTALLATION AND CONFIGURATION
- Install the Alarm System (3)
- Select the car and configure the Alarm System (4)
- Select the direction indicator wiring diagram and connect them to the Alarm System (5)
- Connect the additional equipment if necessary (6)
- Check the System operation and fill up the installation documents (10, 11)