GN7C Installation Manual: Difference between revisions
No edit summary |
No edit summary |
||
| Line 43: | Line 43: | ||
== 3. WIRING DIAGRAM == | == 3. WIRING DIAGRAM == | ||
Install the Alarm System according to the wiring diagram. | Install the Alarm System according to the wiring diagram. | ||
Make sure all connections are secure and insulated according to the vehicle's specific requirements. | Make sure all connections are secure and insulated according to the vehicle's specific requirements. | ||
<center> | |||
[[File:GN7C_Wiring_Diagram.png|800px|thumb|none|Pic. 2. Wiring diagram of the GN7C system.]] | |||
</center> | |||
Revision as of 10:53, 13 April 2026
GN7C Installation Manual
1. SECURITY INFORMATION
The vehicle alarm system shall be installed inside the passenger compartment of the vehicle, in a place difficult to access in accordance with the manufacturer's supplied wiring instructions.
The manufacturer of the alarm system recommends the following:
- Qualified Installation: Choose a qualified vehicle alarm system installer to fit the device.
- Environment: The system unit (see Pic 1) shall be installed in a place free from moisture and other elements that could pose to corrode the device.
- Interference: Install as far as possible from any heat-emitting elements in the passenger compartment and sources of electromagnetic interference (e.g., vehicle computer, fans, relay blocks).
- Condensate Prevention: Avoid mounting the System unit directly onto metal parts of the vehicle to prevent the accumulation of condensate.
- Orientation: Install the System Unit so that the wire connectors exit from the bottom side of the unit.
- Safety: Avoid placing wires next to moving or hot parts of the vehicle.
Circuit Load Limits
Do not overload the following circuits of the alarm system:
| Circuit | Maximum Current |
|---|---|
| Cut-off circuit (Δ symbol) | No more than 25 A |
| Optional control No. 1 circuit (4) | No more than 0.13 A |
| Optional control No. 2 circuit (6) | No more than 0.13 A |
| Siren (square symbol) | No more than 2 A |
| Direction indicator on the right circuit (5) | No more than 7 A |
| Direction indicator on the left circuit (2) | No more than 7 A |
2. SEQUENCE OF SYSTEM INSTALLATION AND CONFIGURATION
- Install the Alarm System (3)
- Select the car and configure the Alarm System (4)
- Select the direction indicator wiring diagram and connect them to the Alarm System (5)
- Connect the additional equipment if necessary (6)
- Check the System operation and fill up the installation documents (10, 11)
3. WIRING DIAGRAM
Install the Alarm System according to the wiring diagram.
Make sure all connections are secure and insulated according to the vehicle's specific requirements.
